Feb 10
It is recommended to configure WPA on your wireless router before your wireless network adapters.
Step 1 Open a web browser and type the IP address of the wireless router in the address bar (default is 192.168.0.1). Press Enter.
Step 2 The default username is admin (all lower case) and the default password is blank (nothing). Click OK.
Step 3 Click the Home tab and then click Wireless to the left.
Step 4 Next to WEP select WPA using the radio buttons.
Step 5 Under 802.1X enter the IP Address, Port and Shared Secret for RADIUS Server 1. Repeat for RADIUS Server 2 if applicable.
Step 6 Click Apply and then Continue to save the new settings.
Tags: DI series, Radius, wireless router, WPA
Feb 10
Step 1: Launch the SharePort Mobile App

Step 2: Click on File and select your file

Step 3: Click on the Favorite Icon to allow for offline viewing and click file to go back

Step 4: Click on Home

Step 5: Scroll over to Favorites and select your file

Step 6: Click on the
Icon to select the application to open the file

Tags: App, Microsoft, SharePort
Feb 10
The tollowing chart contiains the different status for the LED indicator on the DCH-S150 Wi-Fi motion sensor:
WPS |
Blinking Green |
Press for one second to start the WPS connection process. The Power/Status LED will start to blink green. |
Reset |
Solid Red |
Press and hold until the Status LED turns red in order to reset the device back to the factory default settings (for about 10 seconds). |
Power/Status LED |
Solid Green |
The DCH-S150 is successfully connected to your network. |
Blinking Green |
The WPS process is in progress. |
Blinking Orange |
The Motion Sensor is not properly connected with your wireless network. |
Solid Red |
The Motion Sensor is powering on, attempting to upgrade firmware, or the device is defective. |
Off |
If the DCH-S150 will not power on, try plugging the device into another outlet. |
Motion Sensor |
PIR (Passive Infrared) sensor for detecting motion. |
Tags: DCH-S150, LED