Apr 12

Why isn’t the Power/Status LED turning on when I plug in my D-Link DCH-S150?

Others No Comments »
If the Power LED is not turning on, please try the following steps:
a)  Make sure the outlet you are using is working properly. Try plugging
in another device to see if it works.
b)  Make sure that if the outlet is controlled by a light switch, it is in
the ON position.

c)  Try a different outlet to see if the Motion Sensor works there.

Tags:

Apr 10

How do I reset the D-Link DCH-S150 Wi-Fi motion sensor?

Others No Comments »

To reset the D-Link DCH-S150 device:

Step 1. Locate the Reset button on the side of the device.

Step 2. With the device plugged in, press and hold the Reset button until the status LED turns red (for about 10 seconds).

Warning: When you reset your DCH-S150, it will change your settings back to the factory default settings. You will loose your current configuration and be ready to start over.

Tags: ,

Apr 08

What can I do if my QR code scan failed or I get an error while scanning?

Others No Comments »

The mydlink™ Home App version 2.0.0 introduces a more simple, easy to use QR-Code-Scan setup process. This process allows setup of your device by scanning a QR code included with the product.
PLEASE NOTE: Due to ongoing changes in our production lines, certain models may not yet include this QR Setup code and by then unable to benefit from this new setup process. Proceeding with the manual Setup Option is recommended.
For those unable to find the second QR Setup code within your installation card, when presented with the QR Code Setup page select  “Skip QR Code” to continue.

 

Tags: ,

Apr 08

What do the different LED status lights mean on the D-Link DCH-S150 DCH-S160?

Others No Comments »

The tollowing chart contiains the different status for the LED indicator on the D-Link DCH-S150 Wi-Fi motion sensor:

 

WPS Blinking Green Press for one second to start the WPS connection process. The Power/Status LED will start to blink green.
Reset Solid Red Press and hold until the Status LED turns red in order to reset the device back to the factory default settings (for about 10 seconds).
Power/Status LED Solid Green The DCH-S150 is successfully connected to your network.
Blinking Green The WPS process is in progress.
Blinking Orange The Motion Sensor is not properly connected with your wireless network.
Solid Red The Motion Sensor is powering on, attempting to upgrade firmware, or the device is defective.
Off If the DCH-S150 will not power on, try plugging the device into another outlet.
Motion Sensor PIR (Passive Infrared) sensor for detecting motion.

Tags: , ,

css.php