Sep 14

Both the D-Link DCS-6112 and DCS-6113 cameras support two way audio communication so that operators can transmit and receive audio simultaneously.

The two way audio port is set to 5060 by default. It can also be assigned to another port number between 1025 and 65535.

By using the external microphone and an external speaker, users can communicate with people present around the D-Link Network Camera.


Tags: , ,

Sep 14

The hidden button in the pinhole beside the Ethernet socket is used to reset the system or restore the factory default settings. Sometimes resetting the D-Link DCS-6111 will return the system back to a normal state. If the system still has problems after reset, restore the factory settings and install again:



Step 1: Lightly insert a paper clip (or a similar sized tool) into the reset hole on the back of the D-Link camera, press lightly and then release the button.

Step 2:The LED on the front of the camera will begin blinking red and green.

Step 3:When the LED stops the blinking the reset has completed.


Step 1:Insert the paperclip or other tool and hold the button in.

Step 2:Wait for the LED on the front of the camera to blink red and green
and hold the button for 30 seconds.

Step 3:Withdraw the tool after the second cycle of the LED blinking and
a factory restore has been completed.

Tags: ,

Sep 12

Select this option to turn off the LED next to the lens.

This will prevent anyone from observing the operation of the D-Link network camera.

Step 1: Log into the web-based configuration of the camera.

Step 2: Click on Setup icon on the top left corner.

Step 3: Go to System -> Device settings and then check the box for “Turn off the LED indicator”.


Step 4: Click Save button to save the new settings.

Tags: ,

Sep 12

Most SD cards should work with D-Link supported cameras.

The following are SD cards that has been tested.

The maximum capacity is up to 32GB.

SanDisk 1G
SanDisk 2G
SanDisk 4G class4
SanDisk 8G class4
Transcend 1G
Transcend 2G
Transcend 4G class6
Transcend 8G class6
Transcend 16G class6
Transcend 32G class4
Transcend 32G class10
A-DATA 8G class6
A-DATA 16 class6
Toshiba 4G class4
Toshiba 8G class4
PQI 8G class6
Apacer 8G class6
Photofast 8G class6

Tags: ,

Sep 12

Note: Before removing your D-Link camera from your account, please make sure that the camera is connected to your router or has Internet access. The Cameras LED should be lit green.

You can remove your camera from your mydlink account through one the following two methods:

  1. Hard reset of your camera.
  • Locate the reset pinhole located on the back of the mydlink camera


  • Press and hold the RESET button for 6-10 seconds while your camera is powered on. The camera will reboot and will then be at factory defaults.

Use the mydlink website to remove your D-Link camera

  • Sign in to your mydlink account.
  • From the My Devices Tab, Select the camera you want to delete and click Delete Device




  • Enter your mydlink password to confirm deletion of the device.

Note: After removing a camera from your account, please wait for the camera to reboot. This will take up to 2 minutes. The camera LED will turn red, then it will change to green again. This indicates that the camera has been successfully removed from your account, and you can now disconnect the power adapter from your device.

Tags: ,

Prev 1 2 3 4 5 6 7 8 9 10 ... 17 18 19 Next