Feb 26

There are three ways to set up your D-Link Camera DCS-825L:

D-Link-Camera-DCS-825L-Setup1

D-Link-Camera-DCS-825L-Setup2

D-Link-Camera-DCS-825L-Setup3

Although the D-Link DCS-825L comes with a power adapter, when you are on the go you can use a portable USB battery pack (not included) that supplies 5V/2A of power.

Plug in the USB battery pack. The Power LED on the bottom of the camera will turn green when the camera is powered on.

Mounting the Camera

Refer to the steps below for mounting the camera. The DCS-825L is for indoor use only. We suggest you configure the camera before mounting it.

1. Place the mounting base where you want to position the camera and use a pencil to mark the holes.

2. Use a 6mm drill bit to drill two holes that are at least 30mm deep. Use a mallet to insert the wall anchors into the holes.

3. Place the mounting base over the holes that you drilled in the wall. Use the supplied screws to attach the mounting base to the surface of the wall.

4. Place the base cover over the mounting base and screw the camera stem clockwise into the mounting base.

Note: Do not overtighten the screws as this may damage the bracket.

Be Sociable, Share!

Tags: ,

No Comments


(Required)
(Required, will not be published)

css.php