Aug 20

D-Link DGL-4500 Internet settings Dynamic (Cable):

dlink-dgl-4500-internet-settings

My Internet Connection:

Select Dynamic IP (DHCP) to obtain IP Address information automatically from your ISP. Select this option if your ISP does not give you any IP numbers to use. This option is commonly used for Cable modem services.

Enable Advanced DNS Service:

Advanced Domanin Name System (DNS) services enhances your internet performance by getting you the information and web pages you are looking for faster and more reliably. Additionally, it improves your overall Internet experience by correcting many common typo mistakes automatically, taking you where you intended to go and saving you valuable time.

Disclaimer: D-Link makes no warranty as to the availability, reliability, functionality and operation of the Advanced DNS service of its features.

Host Name:

The Host Name is optional but may be required by some ISPs.

Use Unicasting:

Check the box if you are having problems obtaining an IP address from your ISP.

DNS Addresses:

Enter the Primary DNS server IP address assigned by your ISP.

MTU:

Maximum Transmission Unit – you may need to change the MTU for optimal performance with your specific ISP. 1500 is the default MTU.

MAC Address:

The default MAC Address is set to the Internet port’s physical interface MAC address on the Broadband Router. It is not recommended that you change the default MAC address unless required by your ISP. You can use the Clone Your PC’s MAC Address button to replace the Internet port’s MAC address with the MAC address of your Ethernet card.

D-Link DGL-4500 PPPoE (DSL) setup:

dlink-dgl-4500-PPPoE-DSL

Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The software is no longer needed and will not work through a router.

My Internet Connection:

Select PPPoE (Username/Password) from the drop-down menu.

Address Mode:

Select Static if your ISP assigned you the IP address, subnet mask, gateway, and DNS server addresses. In most cases, select Dynamic.

IP Address:

Enter the IP address (Static PPPoE only).

User Name:

Enter your PPPoE user name.

Password:

Enter your PPPoE password and then retype the password in the next box.

Service Name:

Enter the ISP Service Name (optional).

Reconnection Mode:

Select either Always-on, On-Demand, or Manual.

Maximum Idle Time:

Enter the Primary and Secondary DNS Server Addresses (On-Demand only).

DNS Addresses:

Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature, enable Auto-reconnect.

MTU:

Maximum Transmission Unit – you may need to change the MTU for optimal performance with your specific ISP. 1492 is the default MTU.

MAC Address:

The default MAC Address is set to the Internet port’s physical interface MAC address on the Broadband Router. It is not recommended that you change the default MAC address unless required by your ISP. You can use the Clone Your PC’s MAC Address button to replace the Internet port’s MAC address with the MAC address of your Ethernet card.

Be Sociable, Share!

Tags: , , ,

1 Comment


(Required)
(Required, will not be published)

css.php