Oct 19

The D-Link DNS-320 ShareCenterTM Pulse 2-Bay Network Storage shares your documents, photos, music, and videos across the network and on the Internet so family members, friends, or employees can access them. This ShareCenterTM Pulse can hold two 3.5” SATA hard drives and is able to create a central network point for backing up valuable files.

Installation – Windows Only

The Setup Wizard on the CD-ROM will give you step-by-step instructions how to connect, install, and configure your DNS-320.

Step 1:

Insert the supplied CD-ROM into your computer. When the autorun screen appears, click ShareCenterTM Pulse Setup Wizard.

Step 2:

Follow the on-screen instructions. Once complete you can log into the DNS-320 for advanced configuration.

Installation – Non-Windows/Manual Installation

For Mac or Linux users, or for manual installation, follow the steps below:

Step 1:

Remove the top cover of your device by moving the cover lock located on the back of your device and moving the cover lock to the right.

Step 2:

While holding the cover lock, slide the top cover backwards. After sliding the top cover backwards, lift the top cover up to remove it.

Step 3:

Insert a 3.5” SATA hard drive into an available drive bay. Then, re-attach the top cover.

Step 4:

Connect an Ethernet cable to the available Ethernet port. This cable should connect the ShareCenterTM Pulse 2-Bay Network Storage to your local network via a router or switch, or directly to a computer for configuration.

Step 5:

Connect the power adapter to the power receptor.

Step 6:

Open a web browser and enter the IP address of the DNS-320 to access the Web UI. If you have a DHCP-enabled router or server on your network, you may need to check the DHCP table to see what IP address the D-Link DNS-320 was assigned.

D-Link DNS-320 ShareCenterTM Pulse 2-Bay Network Storage

D-Link DNS-320 ShareCenterTM Pulse 2-Bay Network Storage

Note: The computer used to access the ShareCenterTM Pulse web-based configuration manager must be on the same subnet as the ShareCenterTM Pulse. If your network is using a DHCP server and the computer receives IP settings from the DHCP server, the ShareCenterTM Pulse will automatically be in the same subnet.

Be Sociable, Share!

Tags: , , ,

1 Comment


(Required)
(Required, will not be published)

css.php