Mar 21

Make sure you disable or uninstall any PPPoE software such as WinPoet, Broadjump, or Enternet 300 from your computer or you will not be able to connect to the Internet. Do not disable until you´ve downloaded the firmware in Step 1. Please make sure that your modem is not also a router. If it is or you do not know, please contact your ISP and change the modem to Bridge mode.

Step 1: Log into the web-based configuration by typing in the IP address of the router (default:192.168.0.1) in your web browser. Select Admin as the username and type in your password. Leave blank if you have not created or changed your password.

Note: The address 192.168.0.1 is NOT on the Internet. The web-based configuration is built-in to the router.

If the router is already online, you will be taken to the STATUS page after logging in. If this is the case, the router is connected and you do not need to continue with this FAQ.

Step 2: Click the Setup tab and then click Internet on the left side.

dir615-pppoe1

Step 3: Click on the Manual Configure button.

dir615-pppoe2

Step 4: Select PPPoE (username/password) from the My Internet Connection is drop down menu and enter the following settings:

# Address Mode: Select the Dynamic IP radio button, unless your ISP (Internet Service Provider) supplied you with a static IP address.
# Username and Password: Enter the username and password your ISP gave you. In most cases your username is the same as your email address provided by your internet provider (example: yourname@yourisp.com).
# Reconnect Mode: Should be set to On Demand
# MTU and Maximum Idle Time: Should be left at the defaults (MTU: 1492 / Maximum Idle Time: 20) unless specifically instructed otherwise by your ISP.

DIR_PPPoE_3

Step 5: Click on the Save Setting button to save the changes.

DIR_PPPoE_4

If you are connected to the Internet; your Cable Status and Network Status will say Connected,you will have an IP Address, Subnet mask, Default Gateway, Primary DNS Server and Secondary DNS Server. If you do not, click on the Renew Button.

Step 6: Click on Status tab and Device Setting on the left side.

DIR_PPPoE_5

Be Sociable, Share!

Tags: ,

1 Comment

  • At 2013.02.23 15:35, boost your bust said:

    Hi i am kavin, its my first time to commenting anyplace, when i read this piece
    of writing i thought i could also make comment due to this good piece of writing.


    (Required)
    (Required, will not be published)

    css.php