Jan 25
The most important step is creation of a reasonable networking scheme, our FAQs will use the below scheme.
Step 1: Choose Setup->VPN and then Add->IPsec VPN. Fill in the following values.
Name: Whatever you like.
Local Net/Mask: Enter the LAN Net of the DIR.
Remote IP: Enter the WAN_IP of the Hub
Remote Local LAN Newt /Mask: Enter the Concentrated Network from the Hub.
Authentication->Pre-shared Key: Whatever you like
NAT-T Enable: Checked
Keep Alive: Keep Alive
PSF: Perfect Forward Security is on.
Step 2: Choose Save Settings.
Pretty great post. I just stumbled upon your blog and wished to say that I’ve really enjoyed surfing around your blog posts. After all I will be subscribing on your feed and I’m hoping
you write once more very soon!
Wow, this post is pleasant, my younger sister is analyzing these kinds of things, therefore I am going to let know her.
It’s amazing in support of me to have a website, which is beneficial for my knowledge. thanks admin
I enjoy reading an article that will make men and women think.
Also, thank you for allowing me to comment!
Hello, just wanted to say, I loved this post.
It was funny. Keep on posting!
I am no longer positive the place you are getting your information, but great topic.
I needs to spend a while learning more or working out more.
Thanks for great information I was looking for this information for my mission.
Thanks for finally writing about >How do I create a Switch
and Spoke VPN scenario with a DIR-130/330 as Spoke?
| D-Link Blog Home <Loved it!