Feb 24

Step 1: Log into your router – How do I log into my router?


Step 2: Click Features > Quick VPN.



Step 3: Configure the VPN service:


L2TP over IPsec – ENABLED

Username – <Enter a username for the VPN> (You will need this later to connect)

Password – <Enter a password for the VPN> (You will need this later to connect)

PSK – <Enter a Preshared Key for the VPN> (You will need this later to connect)


Click Save.


Router Setup is complete.



Step 4: From the control panel, click Network and Internet.



Step 5: Click Network and Sharing Center.



Step 6: Click Set up a new connection or network.



Step 7: Click Connect to a workplace.



Step 8: Click Use my Internet connection (VPN).



Step 9: Configure the VPN IP address and Name:


Internet Address – Enter in the Public IP address of your router. This can be found on the home page of your router configuration.

Destination Name – Enter a name for the VPN Connection


Put a check next to Don”t connect now, just set it up so I can connect later.



Step 10: Enter your username and password for the VPN (created earlier). Click Create.



Step 11:  Click Close.



Step 12: From the Network and Sharing Center, select Change Adapter Settings from the left panel.



Step 13: Right-click on your new VPN connection and select Properties.



Step 14: Click on the Security Tab, select Layer 2 Tunneling Protocol with IPsec (L2TP/IPSec) and click Advanced Settings.



Step 15: Select Use preshared key for authentication and enter your security key (created earlier). Click OK to apply all settings.



Step 16: Right-click on your new VPN Connection and click Connect.



Step 17: If required, enter your VPN username and password (created earlier). Click Connect.



You should now be connected to your router”s VPN.



Setup is Complete. 

Be Sociable, Share!

Tags: ,

No Comments

(Required, will not be published)