Sep 10

Hardware Overview LEDs

DWL-8610AP-Guide1

Diag. -The light will blink during boot up system auto-check.Once the access point is ready, the light will be off.

5 GHz – When lit, the access point is operating at 5GHz. This light will blink when there is wireless traffic.

2.4 GHz – When lit, the access point is operating at 2.4GHz.This light will blink when there is wireless traffic.

LAN1, LAN2 – Solid light when the Ethernet port is connected to a working port, such as a router or switch. The light will blink
when there is traffic through LAN port.

POWER – The light will blink during boot up. Once solid, the access point is ready.

Installing the Hardware

DWL-8610AP-Guide2

You may power the access point using one of the following methods.

1. Use the power adapter included in the package

2. Connect the access point to an external power-over-Ethernet (POE) switch

DWL-8610AP-Guide3

You may configure the access point using one of the following methods.

1. Directly connect the access point to a computer. You may then configure the access point through its graphical user interface (GUI).

2. Connect the access point to your computer using the included console cable. You may then configure the access point through its command
line interface (CLI)

Mounting Plate Assembly

Step 1: Insert the provided wall anchors in the wall where the mounting plate will be attached.

DWL-8610AP-Guide4

Step 2: Use the provided screws to secure the mounting plate on the wall.

DWL-8610AP-Guide5

Step 3: Attach the remaining screws securely to the back of the D-Link DWL-8610AP.

DWL-8610AP-Guide6

Step 4: Attach the DWL-8610AP to the mounting plate.

DWL-8610AP-Guide7

Step 5: Slide the DWL-8610AP down into the grooves on the mounting plate to secure it to the plate.

DWL-8610AP-Guide8

Be Sociable, Share!

Tags: , , , ,

No Comments


(Required)
(Required, will not be published)

css.php