Oct 29

Step 1: Log into the setup page of the DWC-1000.

Step 2: Go to the Advanced tab. Click on AP Profile.


Step 3: The Profile Status shows the current state of the profile:

  • Configured: The AP Profile is created, but no access points are associated to the Profile
  • Associated: The AP Profile is applied to the access points
  • Associated – Modified: The AP Profile has been modified, but changes haven’t been applied to the APs

Step 4: Check the checkbox for the desired AP Profile. Click on the Apply button.

A message will appear stating the APs will restart, and clients will be disconnected during this time. Click Ok to proceed with pushing out the profile to the APs.


Step 5: When the profile has been pushed to the APs, the Profile Status will change to Associated.

Be Sociable, Share!

Tags: , ,

No Comments

(Required, will not be published)