Aug 22
Firewall rules can be configured on the DWL-G730AP in Router Mode.
Step 1 Open a web browser and type the IP address of the DWL-G730AP in the address bar (default is 192.168.0.30). Press Enter.
Step 2 The default username is admin (all lower case) and the default password is blank (nothing). Click OK
Step 3 Click the Advanced tab and then click Firewall to the left.
Step 4 Configure the following:
- Select Enabled to enable the firewall rule or select Disabled to disable it.
- Name – Enter a name to identify the firewall entry.
- Action Select Allow to allow traffic to pass through or Deny to deny traffic to pass through.
- Source – Specify source details:
- Interface – From the drop-down list select the source interface (WAN, LAN, *).
- IP Range Start – Enter the starting IP address.
- IP Range End – Enter the ending IP address.
- Destination – Specify destination details:
- Interface – From the drop-down list select the destination interface (WAN, LAN, *).
- IP Range Start – Enter the starting IP address.
- IP Range End – Enter the ending IP address.
- Protocol – Select the protocol (TCP, UDP, ICMP, *).
- Port Range – Enter the starting and ending port numbers.
- Schedule – Select Always to enable the firewall rule or select From to enable the firewall rule on a schedule.
Step 5 Click Apply to add the new firewall rule.
Note: Rules at the bottom of the Firewall Rules List have lower priority then those at the top of the list.
Tags: DWL-G730AP, Firewall