Jun 29

I was replaced with a new router and this was unable to send signals more than 10 meters. Signal range was dropped and unable to get in side room.

Answers:

We are sorry to hear that you are having connectivity issues with the DIR-600L. Based on the information you described in your review, D-Link suggests the following: If your router is not performing properly (freezing, automatically rebooting, disconnecting, etc), this could be happening for a number of reasons.

Please check the following:

1. Ensure the router is in a well ventilated area. If the router does not get adequate airflow, it could overheat.

 

Wireless Client Mode D-Link

 

2.Ensure the firmware is up to date. Firmware is the “Brains” of the router, it is the programming that tells it how to work. D-Link will release new firmware versions when bugs are reported and fixed. Upgrading the firmware may correct issues you are experiencing.

3. Perform a factory reset on the router. On the back of the router locate a pinhole marked “RESET”. Press this button with the end of a paperclip for about 8-10 seconds and release it – The light should go off and then come back on. After the router finishes rebooting, you will need to re-configure your settings (for both the Wireless and Internet).

If the issue still persists, please contact our technical support team at: www.dlink.com/support. Thank you for being a D-Link customer.

Be Sociable, Share!

Tags: , , ,

No Comments


(Required)
(Required, will not be published)

css.php