May 07

The D-Link DWL-G730AP is a very good travel wireless AP router, sometimes we forget the password, need to reset to factory settings, this article will tell you two ways.

1.Reset Button

If you have lost your password or are unable to login to the DWL-G730AP then it can be factory reset by doing the following:

Step 1: With the unit on, place a paper clip into the hole on the back on the unit labeled Reset.

Step 2: Hold paper clip down for 10 seconds and release.

How to perform a factory reset on D-Link DWL-G730AP Router

NOTE: DO NOT REPOWER UNIT DURING THIS PROCEDURE.

Step 3: The unit will reboot on its own. Once the WLAN light stops blinking, the unit is reset.

2.Web Configuration

If you are able to login to the D-Link DWL-G730AP then you can perform a factory reset via the web-based configuration by doing the following:

Step 1: Open a web browser and type the IP address of the DWL-G730AP in the address bar (default is 192.168.0.30). Press Enter.

Step 2: The default username is admin (all lower case) and the default password is blank (nothing). Click OK.

Step 3: Click the Tools tab and then click System to the left.

Step 4: Below Restore to Factory Default Settings click Restore.

Step 5: In the Restore to factory settings warning dialog box, click OK.

How to perform a factory reset on D-Link DWL-G730AP Router

NOTE: DO NOT REPOWER UNIT DURING THIS PROCEDURE.

How to perform a factory reset on D-Link DWL-G730AP Router

Step 6: The unit will reboot on its own. Once the WLAN light stops blinking, the unit is reset.

Note: Resetting the D-Link DWL-G730AP does not reset the firmware to an earlier version. It will change all settings back to factory defaults.

Be Sociable, Share!

Tags: , , ,

No Comments


(Required)
(Required, will not be published)

css.php