Aug 05

This FAQ is for the DWL-2100AP and DWL-7100AP access points about DHCP Server Configure.

Step 1: Open a web browser and type the IP address of the access point in the address bar (default is 192.168.0.50). Press Enter

Step 2: The default username is admin (all lower case) and the default password is blank (nothing). Click OK.

Step 3: Click the Advanced tab and then click DHCP on the left side.

Note: If you are connecting to a router or a DHCP server, the DHCP server on the access point should be disabled.

Step 4: By default, DHCP Server is set to Disabled. To enable it, select Enabled using the drop-down list next to Function Enable/Disable. To disable it, select disabled using the drop-down list.

Step 5: Next to Starting IP Address enter the beginning IP address of your range. Next to Ending IP Address enter the ending IP address of your range. By default, the range is 100-199, meaning your clients will receive an IP address between 192.168.0.100 and 192.168.0.199.

Step 6: Enter a DNS server to assign to your clients. If you are behind a router or gateway, enter it´s IP address here.

Step 7: Select a lease time from the drop-down list.

Step 8: Click Apply and then click Continue to save the new settings.

Be Sociable, Share!

Tags: , , ,

1 Comment

  • At 2011.08.30 04:26, garage said:

    […] The D-Link Access Point(DWL-2100AP,DWL-7100AP) DHCP Server Configure | D-Link Blog Home […]


    (Required)
    (Required, will not be published)

    css.php