Mar 25

D-Link DNS-320L Quick Install Guide Manual Installation

Step 1:

Remove the top cover of your device by pressing the push button in and then lift the cover up.

Step 2:

Attach the strap to your hard drive(s) with the supplied screws.

Step 3:

Insert one or two 3.5” SATA hard drive(s) into the drive bay until they are firmly seated. Then, re-attach the top cover.

Step 4:

Plug an Ethernet cable to the Ethernet port on the back of the device and plug the other end to your network via a router or switch, or directly to a computer for configuration.

Step 5:

Connect the power adapter to the device and then connect the other end into a power outlet or surge protector. Press the power button on the front of the device to turn the device on.

Step 6:

Open a web browser and enter the IP address of the D-Link DNS-320L to access the Web UI. If you have a DHCP-enabled router on your network, you may need to check the DHCP table to see what IP address the DNS-320L was assigned.

Note: The computer used to access the ShareCenter® web-based configuration manager must be on the same subnet as the ShareCenter®.

If your network is using a DHCP server and the computer receives IP settings from the DHCP server, the ShareCenter® will automatically be in the same subnet.

Step 7:

Select System Administrator and click the Login button (leave the password blank by default). Once you are logged in, click Management and then click Setup Wizard. Follow the on-screen instructions to configure your D-Link DNS-320L.

Note: Please refer to the manual for more information.

Be Sociable, Share!

Tags: , ,

No Comments


(Required)
(Required, will not be published)

css.php