Jun 22

There are two ways to reset the D-Link DCS camera DCS-1100 or DCS-1130:

1.Step 1: Locate the hole on the side of the camera labeled reset.

Step 2: Insert a paper clip into the hole and hold it down (about 5-7 seconds) and release. The LED on the back of the camera will blink green then Link up.


Note: Do not re-power the unit during this process.

The D-Link camera is now reset to factory defaults and will reboot.

2.The D-Link DCS-1100 and DCS-1130 can also be reset from the web interface.


Be Sociable, Share!

Tags: , , ,

1 Comment

  • At 2022.02.18 09:32, Barak said:

    Thank you a very lot; everything is clear and easy to understand, and everything worked fine for me. Thank you once again.

    (Required, will not be published)