Apr 08

The tollowing chart contiains the different status for the LED indicator on the D-Link DCH-S150 Wi-Fi motion sensor:


WPS Blinking Green Press for one second to start the WPS connection process. The Power/Status LED will start to blink green.
Reset Solid Red Press and hold until the Status LED turns red in order to reset the device back to the factory default settings (for about 10 seconds).
Power/Status LED Solid Green The DCH-S150 is successfully connected to your network.
Blinking Green The WPS process is in progress.
Blinking Orange The Motion Sensor is not properly connected with your wireless network.
Solid Red The Motion Sensor is powering on, attempting to upgrade firmware, or the device is defective.
Off If the DCH-S150 will not power on, try plugging the device into another outlet.
Motion Sensor PIR (Passive Infrared) sensor for detecting motion.
Be Sociable, Share!

Tags: , ,

1 Comment

  • At 2018.03.06 12:34, Nelson Bonner said:

    My house power went out. When it came back on my D-Link N300 DAP-1330 WiFi Range Extender was no longer working. The LED never goes to blinking amber but only non-stop solid red or blinking red. What do I do?

    (Required, will not be published)