Jun 18

Note: This example will demonstrate how to configure a LAN-to-LAN IPSec VPN tunnel between two D-Link DIR-130/DIR-330.

In this example:

Local Network is on 192.168.0.0/24
Remote Network is on 192.168.1.0/24

Configuration of Local Network

Step 1: Open your web browser and type in the IP address of the DIR-130 router (192.168.0.1 by default). Enter the username (admin by default) and password (blank by default), and then click OK.

Step 2: Click on SETUP and select VPN SETTINGS. Choose IPSec from the ADD VPN PROFILE dropdown menu and click Add.

dir-330-vpn-1

Step 3: Configure the IPSec VPN as followed:

Enable Settings: check box to enable
Name: enter a name for the VPN
Encapsulation Mode: Tunnel
Remote IP: select Site to Site and enter the remote Gateway
Remote Local LAN Net /Mask: enter the remote LAN network and Subnet Mask
Authentication Protocol: enter a Pre-shared Key (must be the same as the Remote Side)
Phase 1 IKE Proposal List: leave as is
NAT-T Enabled: leave as is
PFS: check to enable
Phase 2 IPSec Proposal List: leave as is.

dir-330-vpn-2

dir-330-vpn-3

Step 4: Click Save Settings.

Configuration of Remote Network.

Note: Both sides cannot be on the same subnet.

Tags: , , ,

Jul 28

Step 1. Log into the browser of the D-Link DIR-130 router.Default User Name:admin.Password:(Blank).

Step 2. Select Maintenance and Date and time.

Make sure your date and time is synced to your computer or NTP and is showing the correct date and time.

Private Certificates1

Step 3. Select Advanced and Certificates

Provide a Name for your certificate.
Browse and select key from where you saved it on your computer.
Browse and select the certificate from where you saved it on your computer.

Private Certificates2

Step 4. Save Settings.

Private Certificates3

Step 5. Verify certificate is valid.

Tags: , , ,

Jul 28

This article guide you to set remote management on D-Link router.

Step 1: Open your web browser and type in the IP address of the router (192.168.0.1 by default). Enter the username (admin by default) and password (blank by default), and then click OK.

Step 2: Click on the TOOLS tab and select ADMIN.

D-Link DIR-330 as a sample:

remote-management

Step 3: Check the box Enable Remote Management to enable this feature. When enabling remote management, you can specify a specific public IP address on the internet that you want to have access to your router or you can enter an asterisk (*) to allow access from anywhere on the internet.

Step 4: Select a port from the Port dropdown menu to specify the destination port for the remote management.

Step 5: Click on Save Settings.

Tags: , ,

css.php