D-Link Blog Home

The schedule configuration option is used to manage schedule rules for various firewall and parental control features. This will allow you to set a time restriction on when firewire filters will take effect.

Step 1: Open a web browser and type the IP address of the D-Link DIR series router into the address bar (default is 192.168.0.1).

Step 2: The default username is admin (all lower case) and the default password is blank (nothing). Click on OK.

Step 3: Click on the Tools tab at the top and then click on Schedule on the lefthand side.

Step 4: Configure the following:

• Name – Give your schedule a name
• Day(s) – Check the box for All Week or select the desired time frame.
• All Day 24hrs – Enabling this will have the rule active for a period of 24hrs.
• Start and End time – If 24hrs is not checked you will need to configure your start and end time.

Step 5: Click on Save Settings to save your configuration.

Tags: DIR Series, Filters, Firewall, schedules

The Nintendo® DS(NDS) is an 802.11b device. In order to connect your Nintendo® DS to a DIR series, Draft N, router, you will need to confirm that the router is in Mixed Mode.

Step 1: Open a web browser and type the IP address of the DIR series router into the address bar (default is http://192.168.0.1).

Step 2: The default username is admin (all lower case) and the default password is blank (nothing). Click OK.

Step 3: Under Setup, click Wireless Settings on the left hand side.

Step 4: From the 802.11 Mode drop down menu, select Mixed 802.11ng, 802.11g and 802.11b.

Step 5: Click on Save Settings to save your settings.

Note: The Nintendo® DS does not support any version of WPA.

Tags: D-Link Router, DIR Series, NDS, Nintendo

The D-Link DGL and the DIR series routers will measure the available bandwidth coming from your modem upon initial boot.This process can take several moments.

This process can take several moments.

1.Open your web browser and type in the IP address of the router (192.168.0.1 by default).

2.Enter the username (admin) and password (blank by default), and then click Ok or Log In.

3.To check the status of this sequence, you can simply log in to the routers interface and click the STATUS TAB.

If this sequence never fully completes or doesn’t complete properly, try power-cycling both the modem and the router at the same time. Please remember to reconnect the power to the modem first and then the router. Please allow a few moments for the devices to initialize and “sync” up.

Tags: DGL Series, DIR Series, get online