May 06

1.How do I disable SSID broadcast on D-Link DWL-2700AP?

Step 1: Open a web browser and type the IP address of the DWL-2700AP in the address bar (default is 192.168.0.50). Press Enter.

Step 2: The default username is admin (all lower case) and the default password is blank (nothing). Click OK.

Step 3: Click the Home tab and then click Wireless to the left.

Step 4: Next to SSID Broadcast select Disable using the drop-down list.

dwl-2700-ssid-broadcast

Step 5: Click Apply to save the new settings.

2.How do I change the SSID of D-Link DWL-2700AP?

Step 1: Open a web browser and type the IP address of the DWL-2700AP in the address bar (default is 192.168.0.50). Press Enter.

Step 2: The default username is admin (all lower case) and the default password is blank (nothing). Click OK.

Step 3: Click the Home tab and then click Wireless to the left.

Step 4: Next to SSID enter the new SSID.

The SSID (Service Set Identifier) is the workgroup name of your Wireless Network. All devices (access points, wireless routers, and wireless adapters) must have the same SSID to communicate on the Wireless Network. The SSID can be up to 32 numbers, letters, spaces, and dashes. Also, the SSID is case-sensitive.

dwl-2700-change-ssid

Step 5: Click Apply and then click Continue to save the new settings.

3.How to check the operating temperature of D-Link DWL-2700AP?

Step 1: Open a web browser and type the IP address of the D-Link DWL-2700AP in the address bar (default is 192.168.0.50). Press Enter.

Step 2: The default username is admin (all lower case) and the default password is blank (nothing). Click OK.

Step 3: Click the Status tab and then click Indication to the left.

dwl-2700-operating-temperature

The operating temperature of the DWL-2700AP will be displayed in both Celsius and Fahrenheit.

4.How do I configure Telnet on my DWL-2700AP?

Step 1: Open a web browser and type the IP address of the D-Link DWL-2700AP in the address bar (default is 192.168.0.50). Press Enter.

Step 2: The default username is admin (all lower case) and the default password is blank (nothing). Click OK.

Step 3: Click the Tools tab and then click Misc. to the left.

Step 4: To enable Telnet, check Enabled using the check box next to Status. Select a timeout using the drop-down list next to Timeout.

Step 5: Click Apply and then click Continue to save the new settings.

dwl-2700-telnet

Advanced users can use Telnet to configure the DWL-2700AP. Go to Start > Run and type telnet 192.168.0.50 in the Run window and then press Enter. Enter the username (default is admin) and the password (default is blank [nothing]). Telnet commands are not supported by D-Link Tech Support. Use at your own risk.

To prevent users from using Telnet, uncheck the Enable check box next to Status.

Tags: , , ,

css.php