Aug 13

You must open ports on your router to allow incoming traffic while using eMule.

eMule uses three ports*:

  • 4662 (TCP)
  • 4672 (UDP)
  • 4711 (TCP)
  • * To prevent getting a low ID (Firewalled), open additional TCP ports between 4661 and 4665. Also, limit the number of connections in the eMule software. You may need to change the TCP Clientport to something other than 4662.

    emule-dlink

    1.For the DI-5xx, DI-6xx, DI-704P (revC), DI-704UP, DI-754, DI-764, DI-774, DI-784, DI-804HV, DI-808HV, and DI-824VUP:

    Step 1: Open your web browser and enter the IP address of your router (192.168.0.1). Enter username (admin) and your password (leave blank).

    Step 2: Click on Advanced and then click Virtual Server.

    Step 3: Create a new entry:

  • Click Enabled.
  • Enter a name (emule1).
  • Private IP – Enter the IP address of the computer you are running eMule from.
  • Select TCP for Protocol Type
  • Enter 4662 for both Private Port and Public Port
  • Click Always or set a schedule.
  • Step 4: Click Apply and then Continue.

    emule-dlink2

    Step 5: Repeat steps 3 and 4 but name it emule2, select UDP for Protocol Type, and enter 4672 for both Private Port and Public Port.

    Step 6: Repeat steps 3 and 4 but name it emule3, select TCP for Protocol Type, and enter 4711 for both Private Port and Public Port.

    Note: If the screenshots look different (DI-604), then you have the European version of your router which D-Link USA does not support.

    2.For the DI-704P (revA), DI-704, DI-707, DI-711, DI-713, and DI-713P:

    Step 1 Open your web browser and enter the IP address of the router (192.168.0.1). Enter user name (admin) and your password (blank by default). If there is only 1 box, enter admin.

    Step 2 Click on Advanced at the bottom and then click Virtual Server.

    Step 3 Create a new entry:

    • Enter 4661-4665 in the box under Service Ports.
    • Enter the IP address of the computer you want to run eMule from.
    • Check the box under Enable.
    • In the next box down, enter 4672 under Service Ports.
    • Enter the IP address of the computer you want to run eMule from.
    • Check the box under Enable.
    • In the next box down, enter 4711 under Service Ports.
    • Enter the IP address of the computer you want to run eMule from.
    • Check the box under Enable.

    emule-dlink3

    Step 4: Click Save and the click Reboot.

    NOTE: If you can only enter a single port (not a range) and/or are limited to 10 entries, upgrade your firmware to the latest version at support.dlink.com/downloads.

    Tags: , , , , ,

    css.php