1.Reset Button

If you have lost your password or are unable to login to the DWL-G730AP then it can be factory reset by doing the following:

Step 1: With the unit on, place a paper clip into the hole on the back on the unit labeled Reset.

Step 2: Hold paper clip down for 10 seconds and release.

NOTE: DO NOT REPOWER UNIT DURING THIS PROCEDURE.

Step 3: The unit will reboot on its own. Once the WLAN light stops blinking, the unit is reset.

2.Web Configuration

If you are able to login to the D-Link DWL-G730AP then you can perform a factory reset via the web-based configuration by doing the following:

Step 1: Open a web browser and type the IP address of the DWL-G730AP in the address bar (default is 192.168.0.30). Press Enter.

Step 2: The default username is admin (all lower case) and the default password is blank (nothing). Click OK.

Step 3: Click the Tools tab and then click System to the left.

Step 4: Below Restore to Factory Default Settings click Restore.

Step 5: In the Restore to factory settings warning dialog box, click OK.

NOTE: DO NOT REPOWER UNIT DURING THIS PROCEDURE.

Step 6: The unit will reboot on its own. Once the WLAN light stops blinking, the unit is reset.

Note: Resetting the D-Link DWL-G730AP does not reset the firmware to an earlier version. It will change all settings back to factory defaults.

Many people do not set this wireless AP, need to find a user manual, there are two ways to obtain user’s manual:

1.From the D-Link official website(http://www.dlink.com/products/?pid=346),check the support resource,then check “Product Manual”,Save what is the user manual for the.

2.From the FTP(ftp://ftp.dlink.com),Select Folder Wireless,Find the corresponding D-Link Model(DWL-G730AP),select Manual,then download it.

With this user manual, you can easily set the D-Link DWL-G730AP,If you have any questions, please message.