The SSID (Service Set Identifier) is the workgroup name of your wireless network. All devices (access points, wireless routers, and wireless adapters) must have the same SSID to communicate on the Wireless Network.

Step 1: Open a web browser and type the IP address of the VDI-624 in the address bar (default is 192.168.0.1). Press Enter.

Step 2: The default username and password is listed below for your version of firmware:

# Firmware 2.39DDM – The default username is admin and the default password is blank (nothing).
# Firmware 2.43 Build 12 – The default username is admin and the default password is password.

Click OK.

Step 3: Click Wireless on the left side.

Step 4: Next to SSID enter a new SSID.

Note: The SSID can be up to 32 numbers, letters, spaces, and dashes. Also, the SSID is case-sensitive.

Step 5: Click Apply and then click Continue to save the new settings.

How to configure wireless channel on D-Link DI-624?

If you cannot change the wireless channel of your VDI-624 (set to channel 6), this means that Super G™ is enabled. Super G will always be set to channel 6 but it actually uses most of the channel range between 1 and 11, which allows increased bandwidth. If you do not want to use Super G, then disable it and this will allow you to use a specific channel.

Step 1: Open a web browser and type the IP address of the VDI-624 in the address bar (default is 192.168.0.1). Press Enter.

Step 2: The default username and password.

Step 3: Click the Advanced tab at the top and then click Performance on the left.

Step 4: Next to Super G Mode, select Disabled.

Step 5: Click Apply and then click Continue to save the new settings.