D-Link DAP-1320 Wi-Fi Range Extender WPS Setup(Easy Push Button Setup)
1. Plug the DAP-1320 into a wall outlet and verify if the power LED has turned from red to a blinking amber.
2. Press the WPS button on your AP/Router.
Note: Usually the WPS LED will blink once it is pressed. Check your router’s manual for more information.
3.Press and hold the WPS button until the light starts blinking green and then release. Please allow up to two minutes for the WPS process to finish. Once the connection is successful the LED will be solid green.
4. Your AP/Router and DAP-1320 will be connected when the LED light turns solid green.
Note: If connection fails, try moving your DAP-1320 closer to your wireless router/access point and repeat steps 2 and 3.
5. To connect wireless clients to the DAP-1320, use the Wi-Fi Network Name (SSID) and Wi-Fi Password information located on your configuration note.
Tags: DAP-1320, Range Extender, WPS Setup
D-Link DAP-1320 Wi-Fi Range Extender Quick Install Guide Quick Install Guide Suggested Extender Setup
Which Setup Method Should I Use?
WPS Setup (Wi-Fi Protected Setup)
If you have a WPS-enabled router, use the WPS Setup section below to guide you through the setup procedure. This will automatically connect your existing wireless router or access point to your DAP-1320. Note: For more information about using WPS on your router or access point, refer to its manual.
D-Link DAP-1320 Wi-Fi Range Extender WPS Setup(Easy Push Button Setup):
Web Browser Setup
If you do not have an existing wireless router with WPS, use the Web Browser Setup section to connect your DAP-1320 using your computer.
Extender Placement Recommendation
For best results place the DAP-1320 within equal distance between your wireless router/access point and your wireless clients.
Note: Place your DAP-1320 in between your AP/Router and wireless clients.
Tags: DAP-1320, Range Extender, Web Browser Setup, WPS Setup